MIL-DTL-83413/10C
REQUIREMENTS
Grounding plug In accordance with MIL-DTL-83413/4.
Grounding wire 7 X 7 wire in accordance with MIL-DTL-83420, type II, composition B, jacket color
translucent or international orange in accordance with FED-STD-595/22510.
Splices shall not be used.
Part or Identifying Number (PIN):
M83413/10-1 is the assembly, see figure 1.
M83413/10-2 is the cap, see figure 2.
QUALIFICATION
Qualification is not required for this specification sheet. First article inspection shall be a visual and
mechanical inspection in accordance with MIL-DTL-83413.
Certain provisions of this specification are the subject of International Standardization Agreements
AIR-STD 25/26 and NATO STANAG 3632. When revision or cancellation of this specification is proposed
which wilt affect or violate the international agreements concerned, the preparing activity will take
appropriate reconciliation action through international standardization channels, including departmental
standardization offices, if required.
Changes from previous issue. The margins of this specification are marked with vertical lines to indicate
where changes from the previous issue were made. This was done as a convenience only and the
Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and
contractors are cautioned to evaluate the requirements of this document based on the entire content
irrespective of the marginal notations and relationship to the last previous issue.
Referenced documents. In addition to MIL-DTL-83413, this document references the following:
MIL-DTL-83413/4
MIL-DTL-83420
FED-STD-595/22510
AIR-STD 25/26
NATO STANAG 3632
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business