MIL-PRF-19207/36E
REQUIREMENTS:
Interface and physical dimensions: See figures 1 and 2.
Cap and body molding material: Cap and body molding materials shall be selected to enable the fuseholder to
meet the performance requirements of this specification. Additional information and guidance on body molding
material are specified in the notes.
Gasket and o-rings: Gaskets and o-rings shall be used that enable the fuseholder to meet the performance
requirements of this specification. Additional information and guidance on gaskets and o-rings are specified in the
notes.
Shield cap, collar, and associated hardware: Brass, with lusterless black finish on exterior, nonconductive
surfaces, (collar and chain retainer ring excluded).
Fuse accommodation:
Ferrule type:
Size: .250 Inch (6.35 mm), 1.250 inch (31.75 mm) length.
(or equivalent size and style)
Poles: One.
Rating: 30 amperes, 250 volts maximum.
Panel thickness: .125 inch (3.18 mm) maximum.
Nonindicating:
Lamp series resistor: None.
Terminals: Solder lug type.
Enclosure: Watertight, with shield cap secured.
Test fuses:
Temperature rise: F03A125V30A of MIL-PRF-15160/3.
Short circuit: F03A125V30A of MIL-PRF-15160/3.
Mechanical shock: Method II of MIL-PRF-19207.
Terminal strength: 5 pounds.
Torque: Mounting - 20 inch-pounds.
Salt spray (corrosion): Test condition B.
Shield continuity: With fuseholder mounted normally and shield cap in place, electrical resistance from shield cap
to mounting panel shall not exceed 0.5 ohms.
Part or Identifying Number (PIN): FHN55W.
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business