MIL-PRF-19207/5L
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Unless otherwise specified, tolerances are ± 0.02 (0.51 mm) for two place decimals and ±0.005 (0.13mm) for
three-place decimals.
4. Cap and body molding material: It is suggested that type MAI-60, GDI-30F or SDG-F of American Society for
Testing and Materials ASTM-D5948 be considered for meeting the cap and body molding material
requirements of this specification. ASTM-D3935 is also suggested as guidance for cap material.
FIGURE 1. Type FHL14G fuseholder - continued.
REQUIREMENTS:
Interface and physical dimensions: See figure 1.
Cap and body molding material: Cap and body molding materials shall be selected to enable the fuseholder to
meet the performance requirements of this specification. Additional information and guidance on body molding
material are specified in the notes.
Fuse accommodation.
Ferrule type:
Size: 0.813 inch (30.65 mm) diameter, 3 inches (76.2 mm) length.
Styles: MIL-PRF-15160, F16 and F62.
(or equivalent size and Styles)
Poles: One.
Rating: 31-60 amperes, 90-500 volts.
Panel thickness: 0.187 inch (4.75 mm) maximum.
Indicating: Neon lamp with clear cap.
Lamp series resistor: MIL-PRF-39017/2, two resistors, 160,000 ohms, 0.5 watt.
Terminals: Stud type, No. 250-20UNC-2A thread.
Enclosure: Dripproof.
Test fuses:
Temperature rise: F62C500V60A of MIL-PRF-15160/62.
Short circuit:
F62C500V60A of MIL-PRF-15160/62.
Mechanical shock: Method I of MIL-PRF-19207.
Terminal strength: 20 pounds.
Torque: Terminals and cap insert - 15 inch-pounds.
Salt atmosphere (corrosion): Test condition B.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business