MIL-PRF-19207-6 Fuseholders, Extractor Post Type, Blown Fuse Indicating And Nonindicating, Type Fhl15G

Pages 1 - 2 - 3 - 4

MIL-PRF-19207/6P

REQUIREMENTS:

Dimensions and configuration: See figure 1.

Cap and body molding material: It is recommended that types MAI-60, GDI-30F or SDG-F of American Society

for Testing and Materials ASTM-D5948 be considered for meeting the body molding material requirements of this

specification. ASTM-D3935 is also suggested as guidance for cap material.

The military part number is not required on the fuseholder.

Fuse accommodation: MIL-PRF-15160, style F63 or equivalent size and style.

Poles: One.

Rating: 61 amperes to 100 amperes, 90 volts to 500 volts.

Panel thickness: 0.250 inch (6.35 mm) maximum.

Indicating: Neon lamp with clear cap.

Lamp series resistors: MIL-PRF-39017/2, two 160,000 ohms, 0.5 watt. One each lamp lead for indicating model;

none required for nonindicating model.

Nonindicating: No lamp or resistor required. Cap, color, gray.

Terminals: Stud type, No. 5/16-18UNC-2A thread.

Enclosure: Dripproof.

Test fuses:

Temperature rise: F63C500V100A of MIL-PRF-15160/63.

Short circuit: F63C500V100A of MIL-PRF-15160/63.

Mechanical shock: Method I of MIL-PRF-19207.

Terminal strength: 20 pounds.

Fuse clip retention force:

Lower clip: 6 pounds to 9 pounds.

Cap clip:

12 pounds to 16 pounds.

Salt spray (corrosion): Test condition B.

Mounting hardware:

Screw: .250-20UNC-2A trusshead, 2.75 inches (70 mm) long (min) with sealing washer.

Nut: .250-20UNC-2B Hex. A threaded metal insert may be used in lieu of nut.

Part or Identifying Number (PIN): FHL15G - (dash number from table I) supersedes the

military part number: M19207/6 - (dash number from table I).