MIL-PRF-19207-13 Fuseholders, Extractor Post Type, Nonindicating, Type Fhn23W

Pages 1 - 2 - 3

MIL-PRF-19207/13J

Screw: Self-sealing panhead, slotted, stainless steel 8-32NC-2A, .625 inch (15.88 mm) long.

Nut: Hexagonal, .125 inch (3.18 mm) thick stainless steel.

Part or Identifying Number (PIN): FHN23W.

NOTES:

Cap and body molding material: It is recommended that types MAI-60, GDI-30F or SDG-F of American Society

for Testing and Materials ASTM-D5948 be considered for meeting the cap and body molding material

requirements of this specification.

Mounting hardware and gasket: The mounting hardware and gasket shall be supplied loose in a plastic bag.

Referenced documents. In addition to MIL-PRF-19207, this document references the following:

The margins of this specification are marked with vertical lines to indicate where changes from the previous issue

were made. This was done as a convenience only and the Government assumes no liability whatsoever for any

inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this

document based on the entire content irrespective of the marginal notations and relationship to the last previous

issue.

Custodians:

Preparing Activity:

Army - CR

DLA - CC

Navy - SH

Air force - 85

(Project 5920-2012-061)

DLA - CC

Review activities:

Army - EA, MI

Navy - AS, MC

Air Force - 19, 99

NOTE: The activities listed above were interested in this document as of the date of this document. Since

organizations and responsibilities can change, you should verify the currency of the information above using the

ASSIST Online database at https://assist.dla.mil.